IAP-120/120+
- Description
- Reviews (0)
Description
Specifications | ||
IAP-120 | IAP-120+ | |
Physical Ports | ||
10/100Base-T(X) Ports in RJ45 Auto MDI/MDIX | 2 | |
P.O.E. PD port | Present at ETH2 Fully compliant with IEEE 802.3af Power Device specifi cation Over load & short circuit protection Isolation Voltage: 1000 VDC min. Isolation Resistance : 108 ohms min |
|
WLAN interface | ||
Operating Mode | AP/Bridge/Repeater/AP-Client | |
Antenna and connector | 2dBi antenna on reverse SMA connector | |
Radio Frequency Type | DSSS, OFDM | |
Modulation | IEEE802.11b : CCK, DQPSK, DBPSK IEEE802.11g : OFDM with BPSK, QPSK, 16QAM, 64QAM |
|
Frequency Band |
America/FCC : 2.412~2.462 GHz (11 channels)
Europe CE/ETSI : 2.412~2.472 GHz (13 channels) Japan TELEC : 2.412~2.472 GHz,2.484GHz (14 channels) |
|
Transmission Rate | IEEE802.11b : 1/ 2/ 5.5/ 11 Mbps IEEE802.11g : 6/ 9/ 12/ 18/ 24/ 36/ 48/ 54 Mbps |
|
Transmit Power | IEEE802.11b/g : 20dBm Max | |
Receiver Sensitivity | -81dBm @ 11Mbps, PER< 8%; -64dBm @ 54Mbps, PER< 10% |
|
Encryption Security | WEP : (64-bit ,128-bit key supported) WPA : WPA2 : 802.11i(WEP and AES encryption) PSK (256-bit key pre-shared key supported) 802.1X Authentication supported TKIP encryption |
|
Wireless Security | SSID broadcast disable | |
Protocol Support | ||
Protocol | ARP, BOOTP, DHCP, DNS, HTTPs, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP (IEEE 802.1D) | |
LED Indicators | ||
Power Indicator | PWR 1(2)(P.O.E.) / Ready : Red On : Power is on and booting up. Green On : Power is on and functioning Normally. |
|
10/100TX RJ45 Port Indicator | Green for port Link/Act at 100Mbps. Amber for port Link/Act at 10Mbps | |
WLAN LEDs | WLAN Link /ACT : Green WLAN Strength : 1<25%, 2<50%, 3<75%, 4<100% |
|
Fault | Red : Ethernet link down or power down | |
Fault contact | ||
Relay | Relay output to carry capacity of 1A at 24VDC | |
Power | ||
Redundant Input Power | Dual DC inputs. 12-48VDC on 6-pin terminal block | Triple DC inputs, 48VDC from PoE and Dual 12~48VDC on 6-pin terminal block |
Power Consumption (Typ.) | 6 Watts | |
Overload Current Protection | Present | |
Reverse Polarity Protection | Present on terminal block | |
Physical Characteristic | ||
Enclosure | IP-30 | |
Dimension (W x D x H) | 54.2(W) x 106.1(D) x 145.4(H) mm (2.13×4.18×5.72 inch.) | |
Weight (g) | 800 g | 804 g |
Environmental | ||
Storage Temperature | -40 to 85°C (-40 to 185°F) | |
Operating Temperature | -10 to 60°C (14 to 140°F) | |
Operating Humidity | 5% to 95% Non-condensing | |
Regulatory approvals | ||
EMI | FCC Part 15, CISPR (EN55022) class A | |
EMS | EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS),EN61000-4-8, EN61000-4-11 | |
Shock | IEC60068-2-27 | |
Free Fall | IEC60068-2-32 | |
Vibration | IEC60068-2-6 | |
Safety | EN60950-1 | |
MTBF (Hours) (MIL-HDBK-217F2, GB, GC, 25°C ) | 352,982 | 352,594 |
Warranty | 3 years |
Reviews
There are no reviews yet.